Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
It's never been easier to raise, level and stabilize your travel or 5th-wheel trailer. This electric stabilizer spans the width of your rig for maximum support and has dual, 12V motors that function independently for quick, simple leveling.
Features:
Specs:
Average Customer Rating: 4.5 out of 5 stars (86 Customer Reviews)
It's never been easier to raise, level and stabilize your travel or 5th-wheel trailer. This electric stabilizer spans the width of your rig for maximum support and has dual, 12V motors that function independently for quick, simple leveling.These jacks are quality built and held up for a 3 month trip to Alaska. I choose to weld the two halves together to minimize the offset. The heavy material made it easy and very sturdy. The system is powerful enough to lift rear of our RV unit partially off the ground but you need to be careful to support the axles so you don't twist the frame on light trailers.
I love these stabilizers. I wish this size was sold without the motors. One of the motors started operating on its own so I took the motors off and manually set them. They will stop a lot of movement when walking around in your camper. I highly recommend them.
Very pleased. Not that hard to install. These replace the weak stabilizers that came with the trailer. You'll need a jack and an electrical kit to complete the install.
I ordered 2 of these units. I give UPS 1 star because they lost an entire unit so I called etrailer and I give them 5 stars for immediately shipping a third unit. Then the first unit arrived from UPS and they lost the motors and hardware kit. I called etrailer and they are shipping more motors and the hardware kit. Hoping UPS doesn’t lose the parts for the replacements! The photo shows all I received so far for two full kits.
Installed on a 2018 E350 Ford Minnie Winnie. The package arrived really beat up but only a single cover was damaged. It was replaced quickly. Nothing was missing.
I had to shim it down from the frame about 1.5 inches using a bar of 1.5"x3"x 24" inch aluminum stock on each side. Then it would clear the fuel tank and the gray water.
Switches are installed in our garage under the bed. Wiring came from power panel which is fairly close to the switches so it all went fairly well. Wire nuts are not recommended so I had to hunt around to find connectors that would work.
I have not used it for camping so do not how well it will work to stabilize the vehicle. We do a lot of boon docking so will have to have some good blocking to level and stabilize. It feels a little better sitting on the street. I do wish there was a lockout for them being raised before moving the vehicle outside of PARK?
Roger
3/10/2022
After a year of use, they make a huge difference when parked overnight.
I got the jack for three reasons. My original jack was intermittent, it was bent and it did not level the trailer because it had only one motor. The new jack works great and it can level the trailer because it has two motors and the power required. It was not the easiest to install because of the increased size and it will not level the trailer if it is off more that 2 inches or so side to side. In spite of these drawbacks and the fact it added weight to the rear of the trailer I am very happy with the new jack.
Richard
4/25/2018
Good. Only issue I have is it is slower than my old jack
Your going to love this product. I was able to fit on to a 1987 Avion travel trailer I renovated for my sister (spectacular renovation). It made the camper rock solid. You can't feel anybody walking around, no high wind movement. It felt like we set it on a concrete foundation. It is a well designed product I will use in the future if I renovate another classic beauty, even my own every day travel trailer.
Great product.
Jonathan
3/30/2020
Excellent product
Scary at first, but following directions, it bolted right onto the frame, used a floor jack to hold it in place while attaching. Wiring was uncomplicated, except for figuring out where to route the wires. works fine, I am a happy camper!
Glenn F.
2/10/2018
still works great.
I was very satisfied with the excellent service I received. Rose was very helpful. Box was a little tattered but all parts were intact. I installed stabilizers and they work as expected .Very easy to install as I did them myself
Joe
5/27/2016
They are working great just as u expected very good product. Would recommend to anyone. Thanks Again to Rose for her help
i find these easy to operate. installation took a little time as i had to works underneath the camper. i have discovered, the middle of the jacks flex when leveling. i have some heavy angle iron, i am going to reinforce them. before i do that operation, i am going to add more bolts, that may be the simple solution.
overall, excellent product.
Installation was easy, need a helper just to make it safer. CSR people are great very helpful!! Works as promoted and I have recommended this product to other campers.
James F.
7/26/2018
Well after 1 year of use the Jacks are still doing very well we have gone on at least a dozen trips that they have been utilized. I am very glad to have purchase them, the installation was very easy great videos!! Best Regards P.S I have recommended to other campers and have even assisted on installing them.
On my 5 whl the landing gears froze up and would not turn either way. I ordered LC179013 and installed myself. That was s good job for an old 70Yrs fat man to do..
I got them installed and wired up and they work like a champ. That has been over a year ago and have been used alot.
I purchased 4 sets of these for 2 trailers. One motor intermittently will not run unless I remove the cover and turn it by hand. It occurred immediately after installation. Should have returned it.
The product itself is a good product but the packaging for shipment is very bad. I received mine and the box was badly torn apart and tapped back together. I was missing multiple pieces and had to wait until the replacement pieces arrived. Customer service was very helpful with resolving this problem within minutes.
Exact replacement of what was on the Carrilite 5'er with both products, the levelers and the front landing gear.
Fast efficient service as usual!
The product does what we needed it to d o.
Finally got around to installing my PT II Stabilizers 30" front and rear of our 26' Surveyor. Pre - assembled them to make sure they went together ok. Luckily I had two sources for power front & rear which made wiring easy, I used a Buss block to make all positive connections, grounds straight to frame, soldered all connections and heat srinked to seal. Using the 3/8" self tappers was fun.Well got it all together and all works well makes trailer very stable, don't have to worry about scissor jacks collapsing anymore.
It looks like a great product am anxious to install them.
I have a symbol of them in my garage and I have one with a really crooked foot. The bolt hole on the retracting arm was drilled in the wrong place so it is totally crooked, not a deal breaker though. I’m sure the are more than Adequate
I finished the assembly and install of the power twin II stabilizer and have included pictures of the install. This is a good quality unit and I am very happy with how it works.
Bob
Would have been nice to know that it didn't fit my Grand Design Imagine 22MLE without some "frame modifications", and over $xxxx in installation costs.
Warning to new buyers; DO SOME REAL CLOSE MEASURING TO MAKE SURE THE SYSTEM
WILL FIT BETWEEN ALL ATTACHED HARDWARE, LIKE DUMP VALVES AND DROP FRAMES! any modifications will cost you dearly.
Electric motors are very slow, seems like it takes forever to drop each foot.
BUT----------They do work.
After installation the stability or my toy hauler was increased X3. The installation was relatively easy and all that was needed was common tools and a floor jack. Wiring was covered by simple easy to follow instruction. Some shrink wrap and a solder gun make permanent water resistant connections which I recommend.
Little intimidating at first, just took my time and it went together without any major problem. The problem that I had was dealt with quickly. It's solid and well built. Print on the instructions was a little small for my eyes. Having the instructions on line was a great help.
If you are looking for "stabilizers" that are strong enough to handle heavy trailers this is the unit for you. A little inconvenient because of the independent screws but they will lift the weight indicated which is why the stabilizers are in quotations.
The Jacks are considerably more durable well built compared to the Lippert models. The lifting power is real and once on the ground the prevent movement of the RV by orders of magnitude over the other style jacks. I only have one in the center of a long trailer and it has stopped the bouncing and side to side swaying of the trailer. Just stepping onto the stairs to get in its rock solid. Also when all the legs are deployed the doors close way better than they ever had with just the Lippert jacks on the front and back. Definitely recommend to anyone thinking about a better jack than what's provided oem.
Do you have a question about this Camper Jack?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Rrr
9/18/2018
Still working just fine, Ive suggested it to anyone who askes about it.